| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the packet processing functionality of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to inefficient memory management. An attacker could exploit this vulnerability by sending a high rate of IPv4 or IPv6 traffic through an affected device. This traffic would need to match a configured block action in an access control policy. An exploit could allow the attacker to cause a memory exhaustion condition on the affected device, which would result in a DoS for traffic transiting the device, as well as sluggish performance of the management interface. Once the flood is stopped, performance should return to previous states. |
| A vulnerability in the IP fragment-handling implementation of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak on an affected device. This memory leak could prevent traffic from being processed through the device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper error handling when specific failures occur during IP fragment reassembly. An attacker could exploit this vulnerability by sending crafted, fragmented IP traffic to a targeted device. A successful exploit could allow the attacker to continuously consume memory on the affected device and eventually impact traffic, resulting in a DoS condition. The device could require a manual reboot to recover from the DoS condition. Note: This vulnerability applies to both IP Version 4 (IPv4) and IP Version 6 (IPv6) traffic. |
| A vulnerability in the VPN System Logging functionality for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak that can deplete system memory over time, which can cause unexpected system behaviors or device crashes. The vulnerability is due to the system memory not being properly freed for a VPN System Logging event generated when a VPN session is created or deleted. An attacker could exploit this vulnerability by repeatedly creating or deleting a VPN tunnel connection, which could leak a small amount of system memory for each logging event. A successful exploit could allow the attacker to cause system memory depletion, which can lead to a systemwide denial of service (DoS) condition. The attacker does not have any control of whether VPN System Logging is configured or not on the device, but it is enabled by default. |
| A vulnerability in the TCP syslog module of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to exhaust the 1550-byte buffers on an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to a missing boundary check in an internal function. An attacker could exploit this vulnerability by establishing a man-in-the-middle position between an affected device and its configured TCP syslog server and then maliciously modifying the TCP header in segments that are sent from the syslog server to the affected device. A successful exploit could allow the attacker to exhaust buffer on the affected device and cause all TCP-based features to stop functioning, resulting in a DoS condition. The affected TCP-based features include AnyConnect SSL VPN, clientless SSL VPN, and management connections such as Secure Shell (SSH), Telnet, and HTTPS. |
| Multiple vulnerabilities in the Server Message Block (SMB) Protocol preprocessor detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent or remote attacker to cause a denial of service (DoS) condition. For more information about these vulnerabilities, see the Details section of this advisory. |
| Multiple vulnerabilities in the Server Message Block (SMB) Protocol preprocessor detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent or remote attacker to cause a denial of service (DoS) condition. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the processing of SSH connections of Cisco Firepower Management Center (FMC) and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper error handling when an SSH session fails to be established. An attacker could exploit this vulnerability by sending a high rate of crafted SSH connections to the instance. A successful exploit could allow the attacker to cause resource exhaustion, resulting in a reboot on the affected device. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for the Cisco Firepower 2100 Series could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to a logic error, which may prevent ingress buffers from being replenished under specific traffic conditions. An attacker could exploit this vulnerability by sending a series of crafted packets to an affected device. A successful exploit could allow the attacker to consume all input buffers, which are shared between all interfaces, leading to a queue wedge condition in all active interfaces. This situation would cause an affected device to stop processing any incoming traffic and result in a DoS condition until the device is reloaded manually. |
| A vulnerability in the Internet Key Exchange version 1 (IKEv1) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper management of system memory. An attacker could exploit this vulnerability by sending malicious IKEv1 traffic to an affected device. The attacker does not need valid credentials to authenticate the VPN session, nor does the attacker's source address need to match a peer statement in the crypto map applied to the ingress interface of the affected device. An exploit could allow the attacker to exhaust system memory resources, leading to a reload of an affected device. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to the affected software improperly validating IP Version 4 (IPv4) and IP Version 6 (IPv6) packets after the software reassembles the packets (following IP Fragmentation). An attacker could exploit this vulnerability by sending a series of malicious, fragmented IPv4 or IPv6 packets to an affected device. A successful exploit could allow the attacker to cause Snort processes on the affected device to hang at 100% CPU utilization, which could cause the device to stop processing traffic and result in a DoS condition until the device is reloaded manually. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.2.1 and 6.2.2, if the software is running on a Cisco Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCvf91098. |
| A vulnerability in the logging configuration of Secure Sockets Layer (SSL) policies for Cisco FirePOWER System Software 5.3.0 through 6.2.2 could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition due to high consumption of system resources. The vulnerability is due to the logging of certain TCP packets by the affected software. An attacker could exploit this vulnerability by sending a flood of crafted TCP packets to an affected device. A successful exploit could allow the attacker to cause a DoS condition. The success of an exploit is dependent on how an administrator has configured logging for SSL policies for a device. This vulnerability affects Cisco FirePOWER System Software that is configured to log connections by using SSL policy default actions. Cisco Bug IDs: CSCvd07072. |
| gopacket provides packet processing capabilities for Go. Through version 1.7.0, multiple layer decoders use attacker-controlled lengths, counts, or offsets before validating them against packet buffers, allowing a crafted packet decoded through DecodingLayerParser or DecodeFromBytes to trigger an unrecovered panic and remotely deny service. A patch commit is available at 210f25f. |
| Klever-Go is the Go implementation of the Klever blockchain protocol. Versions from 1.7.14 through 1.7.17 are vulnerable to a remotely triggerable denial of service. Both REST APIs are started with the Gin Engine.Run convenience method, which serves requests through Go's default HTTP server with no ReadHeaderTimeout, ReadTimeout, or MaxHeaderBytes configured. As a result, incoming connections that never complete their request headers are held open indefinitely. When a REST listener is reachable beyond localhost through the documented all-interface bind or a Docker port-publish deployment, a single unauthenticated client can open many slow-header connections and hold them open until server file descriptors are exhausted, preventing the API from accepting new connections. This renders the REST API unavailable to legitimate clients. This issue is fixed in version 1.7.18. |
| JupyterHub is software that allows users to create a multi-user server for Jupyter notebooks. Prior to 5.5.0, invalid input to form-based login authenticators can place an unbounded attacker-controlled username in failed-login logs, allowing an unauthenticated attacker to consume logging and storage resources. This issue is fixed in version 5.5.0. |
| The WP MAPS PRO WordPress plugin before 6.1.3 does not perform a capability check in one of its AJAX actions, which is also available to unauthenticated users, and does not restrict the operation it dispatches, allowing unauthenticated attackers to trigger uncontrolled recursion that exhausts server resources, resulting in a Denial of Service. |
| Consul Community Edition and Consul Enterprise 1.3.0 through 2.0.2 are vulnerable to an unauthenticated denial of service in several agent HTTP API endpoints. A remote caller could cause the agent to consume substantial memory before the request was rejected. This vulnerability, CVE-2026-19113, is fixed in Consul 2.0.3 and Consul Enterprise 1.21.17, 1.22.11, and 2.0.3. |
| .NET Denial of Service Vulnerability |
| .NET Denial of Service Vulnerability |
| Windows DNS Client Denial of Service Vulnerability |
| .NET and Visual Studio Denial of Service Vulnerability |
